FABSITE

$ $ $ GET PRICE IN DOLLARS $ $ $

A THEREMIN for £59. . THEREMIN A02 . . THEREMIN 003. . THEREMIN 006
THEREMIN 008. . Clip-On Theremin CO2. . HOME
NEW SOUNDS PAGE click here -
WITH THIS

RING MODULATOR RM1 you can be a
No1DALEK !No1DALEK !No1DALEK !

---

This Model illustrated is an Electronic Music Sound Effects unit capable of producing a very wide range of strange and interesting sounds.
Great for making impressive music, it's ideal for Professional use in Studio Sound Effects, Entertainment, parties etc. Makes a good present for a Musician or Sound Effects enthusiast.

The Instrument plugs into almost any audio system, amplifier, sample unit, sound mixer desk or HI-FI system. It can be used with most other sound effects. Great for Disco and Karaoke.

INTERNET BARGAIN ! MAKES A GREAT PRESENT ! SPECIAL OFFER! TRADE PRICE ON THE NET! Only £37 + pp
PP=£5 (UK) PP=£8 (EUROPE) PP=£12 (REST OF THE WORLD)(Visa etc accepted)
CLICK BELOW TO ORDER:
(Visa etc accepted)
ORDER NOW (Non-Paypal)
For Paypal Orders click below

PURCHASE DETAILS & TOTAL PRICE TO PAY
SPECIAL CUSTOM REQUIREMENTS

PAY IN US DOLLARS:

PAY IN POUNDS:

INSTRUCTIONS
from
NUMBER ONE
HOW TO USE RING MODULATOR RM1

(1)This is a genuine Ring Modulator which has not been 'faked up' in any way such as with 'ring modulator chips' which simulate the sound but are not the same! So it has three sockets which can be used as either inputs or outputs. The two end sockets are high impedance about 20K, the middle one low impedance about 600 ohms. Usually we use the two end sockets as inputs and the middle socket as the output. Inputs should be at line level or a bit above. The output will be at a lower level and may need to be amplified to bring it back up to line level if this is needed.
(2) If you put a sound signal into any one of the inputs without a signal into the other input, then theoretically there should be no signal from the output. In practice there is usually a small leakage signal from the output because the circuit is not perfectly balanced.
(3) If you put a sound signal into both inputs, each will enable the other, so that you will obtain a combined signal from the output, but usually each also affects the other in special ways to give very interesting sound effects.
(4) If you put two discrete but different pitches one into each input, the sound which comes out will not contain much of either one unless they are harmonically related. It will contain the sum and difference frequencies of the two notes. These may not be at all musically related to a piece of music which in they are normally played together, and may sound quite discordant. You may expect some very strange sounds when using the Ring Modulator.
(5) This model Ring Modulator is powered by the sound signals you put into it, so there is no need to use any battery or mains pack.
(6) Model RM1 is a mono ring modulator. Use two for Stereo, or do one track at a time.
(7) The two outer (High impedance) sockets are AC in or out. If either one of these is used as the output, the centre (low impedance) socket can be used as an input. This will respond to either AC or DC input, and in this case it is possible to obtain the original input frequencies from the output as well as their sums and difference frequencies, and to use the low impedance input as a volume modulation input.
(8) We expect to make available a larger model with built - in pre - amplifiers if there is sufficient interest in this, and this would need a power supply or battery.

BUY A RING MODULATOR FROM NUMBER ONE - - - FOR SERIOUS MUSIC OR PARTY FUN - - - GET A RING MODULATOR AS A PRESENT ! ! !

CLICK HERE TO ENQUIRE

CLICK BELOW TO ORDER:
(Visa etc accepted)
ORDER NOW (Non-Paypal)
For Paypal Orders click below

PURCHASE DETAILS & TOTAL PRICE TO PAY
SPECIAL CUSTOM REQUIREMENTS

PAY IN US DOLLARS:

PAY IN POUNDS:

NEW SOUNDS PAGE click here -
A THEREMIN FOR £59 . . THEREMIN A02 . . THEREMIN 003. . THEREMIN 006 . . THEREMIN 008. .
Clip-On Theremin CO2. . HOME

BANNERS and LINKS